Local roofersFree to callNo forms to fill out
Serving Leonia and nearby towns
Menu
Call (551) 348-8956
Metal Roofing

Metal Roof Replacement Leonia, NJ

A roofer in Leonia can replace a metal roof that has rusted through, lost its finish or been riddled with worn screw holes, down to the purlins or deck, so the new roof is set up for decades. Dial (551) 348-8956 to talk with a local roofer about replacing the roof.

A metal roof needs replacing when the metal itself is failing, not just the screws. When panels are perforated by rust, the finish is gone and every screw hole has been enlarged by years of movement, repairs stop keeping up. Older galvanized roofs with little coating left are the common candidates.

There are a few ways to replace a metal roof, and the right one depends on what is underneath. Tearing off lets the roofer see rotten purlins, soft decking and rusted fasteners before anything new is installed. In a retrofit, new panels go over the old roof on a framing system, avoiding tear-off on large or occupied buildings.

Many metal roof replacements are actually shingle roofs getting metal for the first time. That job can be a full tear-off or, where code allows, metal laid over one layer of shingles. Have the age, roof type and leak history ready when you call.

Depending on what the roofer finds, metal roof replacement in Leonia, NJ can go hand in hand with metal roof installation and metal roof repair.

Looking for Leonia metal roof replacement? Call (551) 348-8956 to reach a nearby roofing contractor.

Call now
The process

The metal roof replacement process

Here is how a metal replacement usually goes.

  1. Assess the old roof

    The roofer counts rust-through spots, checks the finish and inspects the purlins or decking from inside the attic or building. This decides tear-off, re-cover or partial panel replacement.

  2. Plan the new roof

    Tear-off, re-cover or metal over shingles is chosen, along with the new panel system, gauge and finish. The new panels are ordered cut to length.

  3. Strip the panels

    Old panels, trim and fasteners are removed and sorted for scrap metal recycling. Sections are opened only when they can be dried in that day.

  4. Fix the purlins

    The structure is repaired so new fasteners bite into solid wood. New screws in rotten wood would fail within a few seasons.

  5. Install the new metal

    The roof is dried in, trimmed and paneled, with new boots and flashing at every penetration. Snow guards and ventilation are added where needed.

What is included

Parts of a metal reroof

Flashing

New trim and boots at walls and penetrations in the same finish as the panels.

Old roof removal

Failed panels and trim come off and taken for recycling.

Framing repair

Damaged structure is repaired before any new metal is installed.

Metal panels

The new metal system replace the old roof.

Retrofit framing

Where suitable, new metal goes over the old roof on sub-framing with fasteners driven into the structure below.

Related service

Metal Roof Panel Replacement Leonia, NJ

When only a few panels are rusted through or torn, metal roof panel replacement can keep the rest of the roof in service. The damaged panel is unscrewed, the laps on either side are freed and a new panel of the same profile is lapped in and fastened. Concealed fastener panels take more time to replace because of the seams.

Many Leonia roofs need only a few panels replaced after a storm or a falling limb. The new panels may look brighter until they weather. Too many swaps, and a full reroof is the smarter route.

Related service

Metal Roof Over Shingles Leonia, NJ

Metal over shingles is a common way to switch to metal without stripping the old roof. Many codes allow it over a single layer of shingles, and the metal usually goes on over new underlayment, a slip sheet or wood battens.

What you give up is a look at the deck. For Leonia homes, the attic check is critical, since rotted decking will not hold fasteners. Any sign of rot, or a second layer of shingles, tips the decision to tear-off.

Local help

Metal Roof Replacement Near Me

Around Leonia, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. Across Leonia and nearby communities including Palisades Park, Fort Lee, Ridgefield Park and Englewood, metal roofs that went decades without fastener work are the usual replacement jobs, which is why the condition of the purlins and deck drives the plan.

For metal roof replacement in Leonia, NJ or nearby towns like Palisades Park, Fort Lee, Ridgefield Park and Englewood, call (551) 348-8956 to reach a roofer who covers your street.

Roofs in this climate

Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Leonia is busiest after a hard winter and before the next one.

Why call

Why act early

Less damage

A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.

Roofers who know Leonia

Roofers in Leonia know the roof types and weather wear common in local homes.

Clear next steps

Ask the roofer about the cause, the options and the estimate before work starts.

Metal Roof Replacement FAQ

How is a single metal roof panel replaced?
Single panel replacement is common on exposed fastener roofs. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. New panels may look brighter than the old ones at first.
Is it a good idea to put metal over shingles?
Where code permits, metal can go over a single layer of shingles. It works best when the deck is sound and the shingles lie flat. Two layers or any rot means the shingles should come off.
Is old metal roofing recycled?
Removed metal panels are generally recycled. The old panels and trim are separated and sent to a recycler. Ask the roofer how disposal is handled before work starts.
What is a metal roof retrofit?
A retrofit, or re-cover, installs new metal over the existing panels using a sub-framing system. It is common on larger buildings where tearing off would disrupt use. The framing must be sound enough to support both layers.
How do I know my metal roof is past repair?
Replacement makes sense once the metal itself is failing across many panels. Rust holes in many panels, a finish worn to bare metal and screw holes that will not hold new fasteners all point toward replacement. Call (551) 348-8956 to have a roofer check the roof and the structure.

More questions? Call (551) 348-8956

Related services

  • Metal Roof Installation

    New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, so the roof handles heat, wind and thermal movement.

    Learn more
  • Metal Roof Repair

    Repairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, matched to exposed fastener and standing seam roofs alike.

    Learn more
  • Roof Replacement

    Replacing an aging roof with new underlayment, flashing, vents and roofing, built to current code from the decking out.

    Learn more
  • Standing Seam Metal Roof

    Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, built to let the metal move without leaking.

    Learn more

Looking for something else?

See all roofing services

Talk to a Leonia roofer about metal roof replacement

Call (551) 348-8956 to talk to a roofer serving Leonia, NJ.

Talk to a local roofer(551) 348-8956Call now

Free to call. No forms to fill out.

Call (551) 348-8956