Roof vents
An exhaust system sized for the attic for a drier attic all year.
A roofer in Leonia can install a new roof in the proper sequence: drip edge, ice and water shield, underlayment, starter strip, flashing, vents and then the roofing itself, whether the roof is going on a stripped deck or as a permitted overlay. One call to (551) 348-8956 reaches a nearby roofing contractor.
Most early roof leaks are installation problems, not material problems. Nails driven above the reinforced strip, flashing left out at a sidewall and short valleys are the kind of mistakes that show up within a few seasons. Those are details you cannot see from the yard, which is why the installer matters so much.
Choosing the material comes first. Dimensional shingles cover most houses, though metal, tile and synthetic products are growing, and each one installs differently. The slope of the roof limits the options, because shingles need a minimum pitch and nearly flat sections need a membrane roof.
Have some basics ready when you call. Say whether the job is a tear-off, an addition or new construction, and whether you have a material or color picked out.
Many roof installation calls in Leonia also turn up a need for roof replacement or shingle roof installation.
Dealing with this in Leonia, NJ right now? Call (551) 348-8956 and describe the problem to a roofer who works in Leonia.
Call nowEach layer protects the one under it, so the order is not optional.
The roof deck must be clean, dry and solid, with any soft plywood or OSB replaced and loose boards renailed. On an overlay, the old shingles must lie flat, and any badly curled ones are cut back or replaced.
Drip edge goes on at the eaves, ice and water shield is rolled out along the eaves and in the valleys, and drip edge is then added along the rakes over the underlayment. Codes in colder areas often require the ice barrier to reach a set distance inside the exterior wall.
Synthetic underlayment or felt covers the rest of the deck, lapped so each row sheds over the one below. Most crews now use synthetic underlayment, which holds up better to foot traffic and weather.
Step flashing is woven in with each course along sidewalls, counter flashing covers it at masonry, kickout flashing sits at the bottom of each wall line and new pipe boots go over every vent. Flashing is where most leaks start, so it is never just caulked in place.
Starter shingles seal the first course, and each shingle is nailed through the marked nail line, not above it. In cold weather, shingles may need hand sealing because the sealant strips will not bond until warm sun hits them.
The crew opens a slot at the ridge for a ridge vent, or installs box vents, and finishes with cap shingles. Balanced intake and exhaust keep the attic drier in winter and cooler in summer.
An exhaust system sized for the attic for a drier attic all year.
Starter strip, field shingles and ridge caps, or the panels and trim for a metal roof with fasteners placed where they belong.
Step, counter and kickout flashing plus new pipe boots so the weak points match the new roof.
Metal edges around the whole roof guides water into the gutters and protects the fascia.
Ice and water shield at the eaves and valleys, with underlayment over the rest of the deck backs up the roofing in wind-driven rain.
A new roof installation can mean a roof on a stripped house, a roof on new framing or a roof on an addition tied into an existing one. Tie-ins between new and old roofs are a common leak point, so they need full ice barrier and careful flashing. It is worth asking how closely the new shingles will match the weathered ones.
Every roofing product comes with instructions that set the nail count, nail placement, minimum slope and vent requirements. A Leonia roofer should be able to explain how many nails per shingle will be used, what underlayment goes down and what ventilation the attic will have. Clear, specific answers are a good sign the details will be done right.
An overlay skips the tear-off and lays new shingles over the current roof. Building codes generally cap asphalt roofs at two layers, so an overlay is only possible on a roof with a single layer, and not over shingles that are badly curled, wet or sitting on soft decking. It means less mess and a faster install.
The trade-offs are real. Nobody can see or repair the decking, the old flashing tends to stay in place, the extra weight sits on the framing, and bumps in the old roof can telegraph through the new shingles. If an overlay is on the table, ask the roofer to confirm the layer count, replace the drip edge and flashing and explain what happens at the next replacement, when both layers must come off.
In Leonia, new roofs go on everything from decades-old homes to recent builds. Across Leonia and nearby places including Palisades Park, Fort Lee, Ridgefield Park and Englewood, storms take the biggest toll on roofs that were installed with shortcuts, and a careful installation is what lets a new roof ride out years of weather.
For roof installation in Leonia, NJ or nearby towns like Palisades Park, Fort Lee, Ridgefield Park and Englewood, call (551) 348-8956 to reach a roofer who covers your street.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Leonia is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Leonia know the roof types and weather wear common in local homes.
Ask the roofer about the cause, the options and the estimate before work starts.
More questions? Call (551) 348-8956
Replacing an aging roof with new underlayment, flashing, vents and roofing, built to current code from the decking out.
Learn moreNew shingle roofs built layer by layer on a sound deck, with nailing and flashing done to the shingle instructions.
Learn moreNew metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, so the roof handles heat, wind and thermal movement.
Learn moreNew construction roofs coordinated with the builder's schedule, with flashing timed around windows and siding.
Learn moreLooking for something else?
See all roofing servicesCall (551) 348-8956 for a local roofer in Leonia and nearby towns.